![]() Not sure power wise though if i can get away with two panasonic 18650's w/3400ma thats the plan but being a major noob that's not based on any calculations but off of what i have seen others use on forums. Plans are to buy a LED engin rgbw 10w star, 2 accent rgb 20ma led's, and i am looking at making a 4ch 1A led driver similar to minus the extra frills. Also picked up 6dof imu-6050 board, a class d 2.5 watt amp, 8ohms 2w speaker, 3 mom switches 2 with led rings (1 for power/aux, 2 for aux/menu/effects). The cut is just outside the two visible resistors one above and one below the main pin lines, leaves the board just slightly wider on both sides than the teensy. I am hoping i didn't screw something up :s The board was too wide and i wasn't planning on using the ac97, headphone jack, or trim pot area. Jumping ahead of myself i already soldered them together (got some leads from the underside of the teensy, namely 29-32, 25, 26 for the sda,scl, pwmx2, rx,tx just in case) Also i cut down the audio adapter. So i am doing a lightsaber using the teensy 3.2 as a main board ( ) Already purchased the 3.2 and the audio adapter board. So i'm building a lightsaber.kinda the current state of things looking for advice anyone is willing to give or comments in general. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |